 Posted: Mon Nov 27, 2006 7:38 pm Post subject: ADM5120 with NEC USB2.0 |
 |
|
Hi,
I have midge working on a NAS device with ADM5120 and NEC USB chip.
Unfortunately, only USB 1.1 works, not USB 2.0. I get this error:
backup# insmod ehci-hcd
PCI: Enabling device 0000:00:03.2 (0000 -> 0002)
ehci_hcd 0000:00:03.2: EHCI Host Controller
ehci_hcd 0000:00:03.2: new USB bus registered, assigned bus number 3
ehci_hcd 0000:00:03.2: irq 7, io mem 0x11402000
ehci_hcd 0000:00:03.2: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb3: configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 5 ports detected
usb 3-3: new high speed USB device using ehci_hcd and address 2
ehci_hcd 0000:00:03.2: Unlink after no-IRQ? Controller is probably using the wrong IRQ.
This happens with kernel 2.4.32 and also with 2.6.16.
USB 1.1 via the NEC chip with OHCI driver works fine.
Does any of you know a solution?
Regards,
Peter |
|
